Numerous anglers might want to have the upside of a Black Box however they don’t utilize downriggers. Stream looking for salmon or shallow water angling for bass are two models. Shallow water jigging is another model. Master Troll built up a transom mounted wire framework that works similarly also in drawing in fish as downriggers. A bit of downrigger link is extended over the transom of a vessel and associated with the Black Box. The field around the vessel would then be able to be acclimated to the ideal voltage.
The transom mount framework is made out of a bit of treated steel downrigger link extended between two separators on the transom of your pontoon. It is situated so it is submerged. A protected wire keeps running from the link up into the pontoon and associates with the Black Box. The Pro-Troll transom mounting pack contains the parts required for this establishment. (1) A bit of downrigger link, (2) three separator cushion mounts to hold the link, (3) a bit of protected tubing and (4) the important equipment to go to the Black Box. The three separators can be fixed to the transom with oneself staying glue included or they can be mounted with screws. The Pro-Troll Transom Mount Kit #1505 can be obtained from Pro-Troll retailers. By and large anglers can discover nearby materials and develop their own transom mount.
Before introducing the transom unit, completely clean the areas for the protected mounting cushions. Clean up all oil, earth and outside materials. Inability to do as such can result in the cushion not staying.
The cushions can be verified to the vessel utilizing the sticky tape on the back of the cushions. For most extreme holding it is suggested that the six tempered steel screws additionally be utilized to join the cushions. It isn’t essential that the #1 and #2 cushions be mounted in the focal point of the transom as appeared in the illustration. They can likewise be mounted to the other side.
(1) Mount the three cushions as appeared. (2) Feed the treated steel wire through the little gap in the #1 cushion and after that through the #2 cushion. Now slide one of the little wire sleeves down by the #2 cushion. Draw the wire tight (if utilizing just the tape mounting don’t over draw as you may break the tape bond on the #1 cushion). Crease the sleeve with a couple of pincers or pleating apparatus; this will verify the wire set up. Run the wire through the #3 cushion and after that through the last sleeve. Pleat the sleeve to keep the wire from turning out. Cut a bit of protection (provided) the length of the rest of the wire less one inch and feed it over the wire. Spot the connector on the finish of the wire and safely crease it set up. Fitting the connector on a white wire originating from the appropriation post into this connector. Ensure the uncovered piece of the treated steel link does not contact any metal parts on the pontoon.
The Black Box can likewise be utilized viably with base sustaining fish like sturgeon and catfish. In this example, it is ideal to utilize a pole and reel with protected wire line. Strip off the protection to leave a short exposed segment close to your trap. You will likewise need to leave an exposed bit of wire some place in your reel. You would then be able to cut a gator cut from the Black Box to your wire line. Both catfish and sturgeon use electro-sensor cells to discover prey. The transom mount will likewise help get these fish by killing the vessel.